* (unwind_command): Clean it up and make it print things out
nicer.
* monitor.c: Add ^C handling capability (mostly ripped off from
remote.c).
* (monitor_printf): Make it check the command echo.
* (monitor_printf_noecho): Similar to above, but doesn't check
for echo.
* (monitor_stop): No longer waits for prompt. That is the job of
the caller. This makes things work much better for monitor_wait,
which waits for the prompt itself.
* (monitor_open): Deal with new monitor_stop semantics. Also,
flush input after sending init strings to get rid of junk that may
be output. Also, don't always send \r to remote. Use
monitor_ops->line_term cuz proper character isn't always \r.
* (monitor_fetch_register): Switch to completely different
algorithm to deal with lame-ass monitors which put spaces in the
middle of numbers, and prompt with a space!!!!!
* (monitor_read_memory_single): New routine to be used with
monitors that can only return one byte/short/long at a time. This
is selected via MO_GETMEM_READ_SINGLE.
* (monitor_load_srec): Use monitor_printf_noecho for sending S
records. Most targets don't echo them.
* (monitor.h): Get rid of cmd_delim. Add line_delim.
* op50n-rom.c (op50n_cmds): Fill it up. Make it work.
* w89k-rom.c: Change all eols from \r to \n. Change load_resp to
^Q to prevent error message.
* config/pa/tm-hppa.h (CALL_DUMMY (for hppro)): Add special
instruction sequence at end to make restore_pc_queue happy.
* monitor.c (monitor_read_memory): Use previously mentioned flag
to send proper format memory examine commands to the w89k monitor.
Also, try to handle bizarre format of memory dump...
* op50-rom.c w89k-rom.c: Update to new monitor.[ch] conventions.
Sun make (with VPATH) work...
* monitor.c monitor.h rom68k-rom.c: Serious cleanup to make IDP
(rom68k) target work right.
* array-rom.c op50-rom.c w89k-rom.c: Partial updates to new
monitor.c interface. More work needs to be done here.
* config/m68k/tm-monitor.h: Change DECR_PC_AFTER_BREAK to 0 to
match the IDP monitor. Also, set NUM_REGS to 18 cuz there's no
floating-point for this card.
to monitor config structure for supported baud rates for a target
and variable stop bits.
* monitor.c (monitor_fetch_register): Store register values in big
endian format on any host.
* monitor.c (monitor_load): check the load type and load the file
accordingly. Default to gr_load_image().
* monitor.c (monitor_load_ascii_srec): Load an ascii file in
srecord format by downloading to the monitor.
* w89k-rom.c, op50n-rom.c: set supported load types.
Kevin Buettner
Jason Molenda
Stan Shebs
Fernando Nasser
John Metzler
Jeff Law
Fred Fish
Stu Grossman
Rob Savoye