linux/arch/cris/arch-v32/mm/mmu.S

142 lines
3.5 KiB
ArmAsm
Raw Normal View History

/*
* Copyright (C) 2003 Axis Communications AB
*
* Authors: Mikael Starvik (starvik@axis.com)
*
* Code for the fault low-level handling routines.
*
*/
#include <asm/page.h>
#include <asm/pgtable.h>
; Save all register. Must save in same order as struct pt_regs.
.macro SAVE_ALL
subq 12, $sp
move $erp, [$sp]
subq 4, $sp
move $srp, [$sp]
subq 4, $sp
move $ccs, [$sp]
subq 4, $sp
move $spc, [$sp]
subq 4, $sp
move $mof, [$sp]
subq 4, $sp
move $srs, [$sp]
subq 4, $sp
move.d $acr, [$sp]
subq 14*4, $sp
movem $r13, [$sp]
subq 4, $sp
move.d $r10, [$sp]
.endm
; Bus fault handler. Extracts relevant information and calls mm subsystem
; to handle the fault.
.macro MMU_BUS_FAULT_HANDLER handler, mmu, we, ex
.globl \handler
\handler:
SAVE_ALL
move \mmu, $srs ; Select MMU support register bank
move.d $sp, $r11 ; regs
moveq 1, $r12 ; protection fault
moveq \we, $r13 ; write exception?
orq \ex << 1, $r13 ; execute?
move $s3, $r10 ; rw_mm_cause
and.d ~8191, $r10 ; Get faulting page start address
jsr do_page_fault
nop
ba ret_from_intr
nop
.endm
; Refill handler. Three cases may occur:
; 1. PMD and PTE exists in mm subsystem but not in TLB
; 2. PMD exists but not PTE
; 3. PMD doesn't exist
; The code below handles case 1 and calls the mm subsystem for case 2 and 3.
; Do not touch this code without very good reasons and extensive testing.
; Note that the code is optimized to minimize stalls (makes the code harder
; to read).
;
; Each page is 8 KB. Each PMD holds 8192/4 PTEs (each PTE is 4 bytes) so each
; PMD holds 16 MB of virtual memory.
; Bits 0-12 : Offset within a page
; Bits 13-23 : PTE offset within a PMD
; Bits 24-31 : PMD offset within the PGD
.macro MMU_REFILL_HANDLER handler, mmu
.globl \handler
\handler:
subq 4, $sp
; (The pipeline stalls for one cycle; $sp used as address in the next cycle.)
move $srs, [$sp]
subq 4, $sp
move \mmu, $srs ; Select MMU support register bank
move.d $acr, [$sp]
subq 4, $sp
move.d $r0, [$sp]
#ifdef CONFIG_SMP
move $s7, $acr ; PGD
#else
move.d per_cpu__current_pgd, $acr ; PGD
#endif
; Look up PMD in PGD
move $s3, $r0 ; rw_mm_cause
lsrq 24, $r0 ; Get PMD index into PGD (bit 24-31)
move.d [$acr], $acr ; PGD for the current process
addi $r0.d, $acr, $acr
move $s3, $r0 ; rw_mm_cause
move.d [$acr], $acr ; Get PMD
beq 1f
; Look up PTE in PMD
lsrq PAGE_SHIFT, $r0
and.w PAGE_MASK, $acr ; Remove PMD flags
and.d 0x7ff, $r0 ; Get PTE index into PMD (bit 13-23)
addi $r0.d, $acr, $acr
move.d [$acr], $acr ; Get PTE
beq 2f
move.d [$sp+], $r0 ; Pop r0 in delayslot
; Store in TLB
move $acr, $s5
; Return
move.d [$sp+], $acr
move [$sp], $srs
addq 4, $sp
rete
rfe
1: ; PMD missing, let the mm subsystem fix it up.
move.d [$sp+], $r0 ; Pop r0
2: ; PTE missing, let the mm subsystem fix it up.
move.d [$sp+], $acr
move [$sp], $srs
addq 4, $sp
SAVE_ALL
move \mmu, $srs
move.d $sp, $r11 ; regs
clear.d $r12 ; Not a protection fault
move.w PAGE_MASK, $acr
move $s3, $r10 ; rw_mm_cause
btstq 9, $r10 ; Check if write access
smi $r13
and.w PAGE_MASK, $r10 ; Get VPN (virtual address)
jsr do_page_fault
and.w $acr, $r10
; Return
ba ret_from_intr
nop
.endm
; This is the MMU bus fault handlers.
MMU_REFILL_HANDLER i_mmu_refill, 1
MMU_BUS_FAULT_HANDLER i_mmu_invalid, 1, 0, 0
MMU_BUS_FAULT_HANDLER i_mmu_access, 1, 0, 0
MMU_BUS_FAULT_HANDLER i_mmu_execute, 1, 0, 1
MMU_REFILL_HANDLER d_mmu_refill, 2
MMU_BUS_FAULT_HANDLER d_mmu_invalid, 2, 0, 0
MMU_BUS_FAULT_HANDLER d_mmu_access, 2, 0, 0
MMU_BUS_FAULT_HANDLER d_mmu_write, 2, 1, 0