From 5c8c755ce508a9d41d8a8d80fff387cb4e2929fc Mon Sep 17 00:00:00 2001 From: Lennert Buytenhek Date: Sat, 12 Nov 2005 21:58:05 +0000 Subject: [PATCH] [SERIAL] don't disable xscale serial ports after autoconfig xscale-type UARTs have an extra bit (UUE) in the IER register that has to be written as 1 to enable the UART. At the end of autoconfig() in drivers/serial/8250.c, the IER register is unconditionally written as zero, which turns off the UART, and makes any subsequent printch() hang the box. Since other 8250-type UARTs don't have this enable bit and are thus always 'enabled' in this sense, it can't hurt to enable xscale-type serial ports all the time as well. The attached patch changes the autoconfig() exit path to see if the port has an UUE enable bit, and if yes, to write UUE=1 instead of just putting a zero into IER, using the same test as is used at the beginning of serial8250_console_write(). Signed-off-by: Lennert Buytenhek Signed-off-by: Russell King --- drivers/serial/8250.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-) diff --git a/drivers/serial/8250.c b/drivers/serial/8250.c index 3742753241ee..e08510d09ff6 100644 --- a/drivers/serial/8250.c +++ b/drivers/serial/8250.c @@ -999,7 +999,10 @@ static void autoconfig(struct uart_8250_port *up, unsigned int probeflags) serial_outp(up, UART_MCR, save_mcr); serial8250_clear_fifos(up); (void)serial_in(up, UART_RX); - serial_outp(up, UART_IER, 0); + if (up->capabilities & UART_CAP_UUE) + serial_outp(up, UART_IER, UART_IER_UUE); + else + serial_outp(up, UART_IER, 0); out: spin_unlock_irqrestore(&up->port.lock, flags);