From 6827a46f59942208d45e0c40e53f649bfc7792ed Mon Sep 17 00:00:00 2001 From: Roman Byshko Date: Mon, 10 Nov 2014 19:55:06 +0100 Subject: [PATCH] phy: sun4i: add support for USB phy0 The driver for sun4i USB phys currently supports only phy1 and phy2 which are used for USB host controllers. This patch adds support for USB phy0, which is used by the musb hdrc USB controller. Signed-off-by: Roman Byshko Acked-by: Maxime Ripard Signed-off-by: Kishon Vijay Abraham I --- drivers/phy/phy-sun4i-usb.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i-usb.c index 0baf5efc8a40..6bd2b0c972cc 100644 --- a/drivers/phy/phy-sun4i-usb.c +++ b/drivers/phy/phy-sun4i-usb.c @@ -157,6 +157,10 @@ static int sun4i_usb_phy_init(struct phy *_phy) return ret; } + /* Enable USB 45 Ohm resistor calibration */ + if (phy->index == 0) + sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1); + /* Adjust PHY's magnitude and rate */ sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5); @@ -213,7 +217,7 @@ static struct phy *sun4i_usb_phy_xlate(struct device *dev, { struct sun4i_usb_phy_data *data = dev_get_drvdata(dev); - if (WARN_ON(args->args[0] == 0 || args->args[0] >= data->num_phys)) + if (args->args[0] >= data->num_phys) return ERR_PTR(-ENODEV); return data->phys[args->args[0]].phy; @@ -255,8 +259,7 @@ static int sun4i_usb_phy_probe(struct platform_device *pdev) if (IS_ERR(data->base)) return PTR_ERR(data->base); - /* Skip 0, 0 is the phy for otg which is not yet supported. */ - for (i = 1; i < data->num_phys; i++) { + for (i = 0; i < data->num_phys; i++) { struct sun4i_usb_phy *phy = data->phys + i; char name[16];