Merge remote-tracking branches 'spi/topic/armada', 'spi/topic/axi', 'spi/topic/davinci' and 'spi/topic/fsl-dspi' into spi-next

Documentation/devicetree/bindings/spi/spi-davinci.txt

@@ -24,6 +24,16 @@ Required properties:
 	based on a specific SoC configuration.
 - interrupts: interrupt number mapped to CPU.
 - clocks: spi clk phandle
+          For 66AK2G this property should be set per binding,
+          Documentation/devicetree/bindings/clock/ti,sci-clk.txt
+
+SoC-specific Required Properties:
+
+The following are mandatory properties for Keystone 2 66AK2G SoCs only:
+
+- power-domains:	Should contain a phandle to a PM domain provider node
+			and an args specifier containing the SPI device id
+			value. This property is as per the binding,
 
 Optional:
 - cs-gpios: gpio chip selects

drivers/spi/Kconfig

@@ -379,7 +379,7 @@ config SPI_FSL_DSPI
 	tristate "Freescale DSPI controller"
 	select REGMAP_MMIO
 	depends on HAS_DMA
-	depends on SOC_VF610 || SOC_LS1021A || ARCH_LAYERSCAPE || COMPILE_TEST
+	depends on SOC_VF610 || SOC_LS1021A || ARCH_LAYERSCAPE || M5441x || COMPILE_TEST
 	help
 	  This enables support for the Freescale DSPI controller in master
 	  mode. VF610 platform uses the controller.

drivers/spi/spi-armada-3700.c

@@ -213,7 +213,7 @@ static void a3700_spi_mode_set(struct a3700_spi *a3700_spi,
 }
 
 static void a3700_spi_clock_set(struct a3700_spi *a3700_spi,
-				unsigned int speed_hz, u16 mode)
+				unsigned int speed_hz)
 {
 	u32 val;
 	u32 prescale;
@@ -231,17 +231,6 @@ static void a3700_spi_clock_set(struct a3700_spi *a3700_spi,
 		val |= A3700_SPI_CLK_CAPT_EDGE;
 		spireg_write(a3700_spi, A3700_SPI_IF_TIME_REG, val);
 	}
-
-	val = spireg_read(a3700_spi, A3700_SPI_IF_CFG_REG);
-	val &= ~(A3700_SPI_CLK_POL | A3700_SPI_CLK_PHA);
-
-	if (mode & SPI_CPOL)
-		val |= A3700_SPI_CLK_POL;
-
-	if (mode & SPI_CPHA)
-		val |= A3700_SPI_CLK_PHA;
-
-	spireg_write(a3700_spi, A3700_SPI_IF_CFG_REG, val);
 }
 
 static void a3700_spi_bytelen_set(struct a3700_spi *a3700_spi, unsigned int len)
@@ -423,7 +412,7 @@ static void a3700_spi_transfer_setup(struct spi_device *spi,
 
 	a3700_spi = spi_master_get_devdata(spi->master);
 
-	a3700_spi_clock_set(a3700_spi, xfer->speed_hz, spi->mode);
+	a3700_spi_clock_set(a3700_spi, xfer->speed_hz);
 
 	byte_len = xfer->bits_per_word >> 3;
 
@@ -584,6 +573,8 @@ static int a3700_spi_prepare_message(struct spi_master *master,
 
 	a3700_spi_bytelen_set(a3700_spi, 4);
 
+	a3700_spi_mode_set(a3700_spi, spi->mode);
+
 	return 0;
 }
 

drivers/spi/spi-axi-spi-engine.c

@@ -553,7 +553,7 @@ err_put_master:
 
 static int spi_engine_remove(struct platform_device *pdev)
 {
-	struct spi_master *master = platform_get_drvdata(pdev);
+	struct spi_master *master = spi_master_get(platform_get_drvdata(pdev));
 	struct spi_engine *spi_engine = spi_master_get_devdata(master);
 	int irq = platform_get_irq(pdev, 0);
 
@@ -561,6 +561,8 @@ static int spi_engine_remove(struct platform_device *pdev)
 
 	free_irq(irq, master);
 
+	spi_master_put(master);
+
 	writel_relaxed(0xff, spi_engine->base + SPI_ENGINE_REG_INT_PENDING);
 	writel_relaxed(0x00, spi_engine->base + SPI_ENGINE_REG_INT_ENABLE);
 	writel_relaxed(0x01, spi_engine->base + SPI_ENGINE_REG_RESET);

drivers/spi/spi-fsl-dspi.c

@@ -32,6 +32,7 @@
 #include <linux/regmap.h>
 #include <linux/sched.h>
 #include <linux/spi/spi.h>
+#include <linux/spi/spi-fsl-dspi.h>
 #include <linux/spi/spi_bitbang.h>
 #include <linux/time.h>
 
@@ -151,6 +152,11 @@ static const struct fsl_dspi_devtype_data ls2085a_data = {
 	.max_clock_factor = 8,
 };
 
+static const struct fsl_dspi_devtype_data coldfire_data = {
+	.trans_mode = DSPI_EOQ_MODE,
+	.max_clock_factor = 8,
+};
+
 struct fsl_dspi_dma {
 	/* Length of transfer in words of DSPI_FIFO_SIZE */
 	u32 curr_xfer_len;
@@ -741,6 +747,7 @@ static int dspi_setup(struct spi_device *spi)
 {
 	struct chip_data *chip;
 	struct fsl_dspi *dspi = spi_master_get_devdata(spi->master);
+	struct fsl_dspi_platform_data *pdata;
 	u32 cs_sck_delay = 0, sck_cs_delay = 0;
 	unsigned char br = 0, pbr = 0, pcssck = 0, cssck = 0;
 	unsigned char pasc = 0, asc = 0, fmsz = 0;
@@ -761,11 +768,18 @@ static int dspi_setup(struct spi_device *spi)
 			return -ENOMEM;
 	}
 
-	of_property_read_u32(spi->dev.of_node, "fsl,spi-cs-sck-delay",
-			&cs_sck_delay);
+	pdata = dev_get_platdata(&dspi->pdev->dev);
 
-	of_property_read_u32(spi->dev.of_node, "fsl,spi-sck-cs-delay",
-			&sck_cs_delay);
+	if (!pdata) {
+		of_property_read_u32(spi->dev.of_node, "fsl,spi-cs-sck-delay",
+				&cs_sck_delay);
+
+		of_property_read_u32(spi->dev.of_node, "fsl,spi-sck-cs-delay",
+				&sck_cs_delay);
+	} else {
+		cs_sck_delay = pdata->cs_sck_delay;
+		sck_cs_delay = pdata->sck_cs_delay;
+	}
 
 	chip->mcr_val = SPI_MCR_MASTER | SPI_MCR_PCSIS |
 		SPI_MCR_CLR_TXF | SPI_MCR_CLR_RXF;
@@ -949,6 +963,7 @@ static int dspi_probe(struct platform_device *pdev)
 	struct fsl_dspi *dspi;
 	struct resource *res;
 	void __iomem *base;
+	struct fsl_dspi_platform_data *pdata;
 	int ret = 0, cs_num, bus_num;
 
 	master = spi_alloc_master(&pdev->dev, sizeof(struct fsl_dspi));
@@ -969,25 +984,34 @@ static int dspi_probe(struct platform_device *pdev)
 	master->bits_per_word_mask = SPI_BPW_MASK(4) | SPI_BPW_MASK(8) |
 					SPI_BPW_MASK(16);
 
-	ret = of_property_read_u32(np, "spi-num-chipselects", &cs_num);
-	if (ret < 0) {
-		dev_err(&pdev->dev, "can't get spi-num-chipselects\n");
-		goto out_master_put;
-	}
-	master->num_chipselect = cs_num;
+	pdata = dev_get_platdata(&pdev->dev);
+	if (pdata) {
+		master->num_chipselect = pdata->cs_num;
+		master->bus_num = pdata->bus_num;
 
-	ret = of_property_read_u32(np, "bus-num", &bus_num);
-	if (ret < 0) {
-		dev_err(&pdev->dev, "can't get bus-num\n");
-		goto out_master_put;
-	}
-	master->bus_num = bus_num;
+		dspi->devtype_data = &coldfire_data;
+	} else {
 
-	dspi->devtype_data = of_device_get_match_data(&pdev->dev);
-	if (!dspi->devtype_data) {
-		dev_err(&pdev->dev, "can't get devtype_data\n");
-		ret = -EFAULT;
-		goto out_master_put;
+		ret = of_property_read_u32(np, "spi-num-chipselects", &cs_num);
+		if (ret < 0) {
+			dev_err(&pdev->dev, "can't get spi-num-chipselects\n");
+			goto out_master_put;
+		}
+		master->num_chipselect = cs_num;
+
+		ret = of_property_read_u32(np, "bus-num", &bus_num);
+		if (ret < 0) {
+			dev_err(&pdev->dev, "can't get bus-num\n");
+			goto out_master_put;
+		}
+		master->bus_num = bus_num;
+
+		dspi->devtype_data = of_device_get_match_data(&pdev->dev);
+		if (!dspi->devtype_data) {
+			dev_err(&pdev->dev, "can't get devtype_data\n");
+			ret = -EFAULT;
+			goto out_master_put;
+		}
 	}
 
 	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);

include/linux/spi/spi-fsl-dspi.h

@@ -0,0 +1,31 @@
+/*
+ * Freescale DSPI controller driver
+ *
+ * Copyright (c) 2017 Angelo Dureghello <angelo@sysam.it>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#ifndef SPI_FSL_DSPI_HEADER_H
+#define SPI_FSL_DSPI_HEADER_H
+
+/**
+ * struct fsl_dspi_platform_data - platform data for the Freescale DSPI driver
+ * @bus_num: board specific identifier for this DSPI driver.
+ * @cs_num: number of chip selects supported by this DSPI driver.
+ */
+struct fsl_dspi_platform_data {
+	u32 cs_num;
+	u32 bus_num;
+	u32 sck_cs_delay;
+	u32 cs_sck_delay;
+};
+
+#endif /* SPI_FSL_DSPI_HEADER_H */