pinctrl: baytrail: Do not clear IRQ flags on direct-irq enabled pins

Suspending Goodix touchscreens requires changing the interrupt pin to
output before sending them a power-down command. Followed by wiggling
the interrupt pin to wake the device up, after which it is put back
in input mode.

On Bay Trail devices with a Goodix touchscreen direct-irq mode is used
in combination with listing the pin as a normal GpioIo resource.

This works fine, until the goodix driver gets rmmod-ed and then insmod-ed
again. In this case byt_gpio_disable_free() calls
byt_gpio_clear_triggering() which clears the IRQ flags and after that the
(direct) IRQ no longer triggers.

This commit fixes this by adding a check for the BYT_DIRECT_IRQ_EN flag
to byt_gpio_clear_triggering().

Note that byt_gpio_clear_triggering() only gets called from
byt_gpio_disable_free() for direct-irq enabled pins, as these are excluded
from the irq_valid mask by byt_init_irq_valid_mask().

Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
This commit is contained in:
Hans de Goede 2019-12-28 00:04:47 +01:00 committed by Andy Shevchenko
parent f068275723
commit a23680594d
1 changed files with 7 additions and 1 deletions

View File

@ -742,7 +742,13 @@ static void byt_gpio_clear_triggering(struct intel_pinctrl *vg, unsigned int off
raw_spin_lock_irqsave(&byt_lock, flags);
value = readl(reg);
value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
/* Do not clear direct-irq enabled IRQs (from gpio_disable_free) */
if (value & BYT_DIRECT_IRQ_EN)
/* nothing to do */ ;
else
value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
writel(value, reg);
raw_spin_unlock_irqrestore(&byt_lock, flags);
}