serial: ar933x_uart: set UART_CS_{RX,TX}_READY_ORIDE
[ Upstream commit 87c5cbf71e
]
On AR934x this UART is usually not initialized by the bootloader
as it is only used as a secondary serial port while the primary
UART is a newly introduced NS16550-compatible.
In order to make use of the ar933x-uart on AR934x without RTS/CTS
hardware flow control, one needs to set the
UART_CS_{RX,TX}_READY_ORIDE bits as other than on AR933x where this
UART is used as primary/console, the bootloader on AR934x typically
doesn't set those bits.
Setting them explicitely on AR933x should not do any harm, so just
set them unconditionally.
Tested-by: Chuanhong Guo <gch981213@gmail.com>
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
Link: https://lore.kernel.org/r/20200207095335.GA179836@makrotopia.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
This commit is contained in:
parent
1cb3c0cecc
commit
c2d5c4df27
|
@ -286,6 +286,10 @@ static void ar933x_uart_set_termios(struct uart_port *port,
|
|||
ar933x_uart_rmw_set(up, AR933X_UART_CS_REG,
|
||||
AR933X_UART_CS_HOST_INT_EN);
|
||||
|
||||
/* enable RX and TX ready overide */
|
||||
ar933x_uart_rmw_set(up, AR933X_UART_CS_REG,
|
||||
AR933X_UART_CS_TX_READY_ORIDE | AR933X_UART_CS_RX_READY_ORIDE);
|
||||
|
||||
/* reenable the UART */
|
||||
ar933x_uart_rmw(up, AR933X_UART_CS_REG,
|
||||
AR933X_UART_CS_IF_MODE_M << AR933X_UART_CS_IF_MODE_S,
|
||||
|
@ -418,6 +422,10 @@ static int ar933x_uart_startup(struct uart_port *port)
|
|||
ar933x_uart_rmw_set(up, AR933X_UART_CS_REG,
|
||||
AR933X_UART_CS_HOST_INT_EN);
|
||||
|
||||
/* enable RX and TX ready overide */
|
||||
ar933x_uart_rmw_set(up, AR933X_UART_CS_REG,
|
||||
AR933X_UART_CS_TX_READY_ORIDE | AR933X_UART_CS_RX_READY_ORIDE);
|
||||
|
||||
/* Enable RX interrupts */
|
||||
up->ier = AR933X_UART_INT_RX_VALID;
|
||||
ar933x_uart_write(up, AR933X_UART_INT_EN_REG, up->ier);
|
||||
|
|
Loading…
Reference in New Issue