15e0c69436
Prior to 2.6.18rc1 you could install with devices on a JMicron chipset using the "all-generic-ide" option. As of this kernel the AHCI driver grabs the controller and rams it into AHCI mode losing the PATA ports and making CD drives and the like vanish. The all-generic-ide option fails because the AHCI driver grabbed the PCI device and reconfigured it. To fix this three things are needed. #1 We must put the chip into dual function mode #2 The AHCI driver must grab only function 0 (already in your rc1 tree) #3 Something must grab the PATA ports The attached patch is the minimal risk edition of this. It puts the chip into dual function mode so that AHCI will grab the SATA ports without losing the PATA ports. To keep the risk as low as possible the third patch adds the PCI identifiers for the PATA port and the FN check to the ide-generic driver. There is a more featured jmicron driver on its way but that adds risk and the ide-generic support is sufficient to install and run a system. The actual chip setup done by the quirk is the precise setup recommended by the vendor. (The JMB368 appears only in the ide-generic entry as it has no AHCI so does not need the quirk) Signed-off-by: Alan Cox <alan@redhat.com> Acked-by: Jeff Garzik <jgarzik@pobox.com> Signed-off-by: Linus Torvalds <torvalds@osdl.org> |
||
|---|---|---|
| .. | ||
| hotplug | ||
| pcie | ||
| .gitignore | ||
| access.c | ||
| bus.c | ||
| hotplug.c | ||
| Kconfig | ||
| Makefile | ||
| msi-altix.c | ||
| msi-apic.c | ||
| msi.c | ||
| msi.h | ||
| pci-acpi.c | ||
| pci-driver.c | ||
| pci-sysfs.c | ||
| pci.c | ||
| pci.h | ||
| probe.c | ||
| proc.c | ||
| quirks.c | ||
| remove.c | ||
| rom.c | ||
| search.c | ||
| setup-bus.c | ||
| setup-irq.c | ||
| setup-res.c | ||
| syscall.c | ||