linux/drivers/iio/common/st_sensors
Linus Walleij 7ba4b884b7 iio: st_sensors: use the helper function
The ST sensors can be used as a trigger for its own triggered buffer
but it is also possible to use an external trigger: a HRTimer or
even a different sensor (!) as trigger. In that case we should not
pick the timestamp from our own interrupt top half even if it is
active.

This could practically happen if some other sensor is using the
ST sensor as trigger but the ST sensor itself is using e.g.
an HRTimer as trigger. So the trigger is on, but not used by us.

We used to assume that whenever the hardware interrupt is turned
on, we are using it for our own trigger, but this is an
oversimplification.

Handle this logically by using the iio_trigger_using_own() helper.

Cc: Giuseppe Barba <giuseppe.barba@st.com>
Cc: Denis Ciocca <denis.ciocca@st.com>
Cc: Crestez Dan Leonard <leonard.crestez@intel.com>
Cc: Gregor Boirie <gregor.boirie@parrot.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
2016-09-10 16:49:25 +01:00
..
Kconfig
Makefile
st_sensors_buffer.c iio: st_sensors: use the helper function 2016-09-10 16:49:25 +01:00
st_sensors_core.c iio: st_sensors: fix errorcheck for regulators 2016-09-03 17:25:54 +01:00
st_sensors_core.h iio: st_sensors: support active-low interrupts 2016-01-10 12:35:32 +00:00
st_sensors_i2c.c iio:st_sensors: emulate SMBus block read if needed 2016-05-29 16:04:17 +01:00
st_sensors_spi.c iio: common: remove unnecessary sizeof(u8) 2014-12-12 12:28:25 +00:00
st_sensors_trigger.c fix:iio:common:st_sensors:st_sensors_trigger:mark symbols static where possible 2016-08-29 20:13:12 +01:00