d9862cfbe2
- Support for the MIPSr6 MemoryMapID register & Global INValidate TLB (GINVT) instructions, allowing for more efficient TLB maintenance when running on a CPU such as the I6500 that supports these. - Enable huge page support for MIPS64r6. - Optimize post-DMA cache sync by removing that code entirely for kernel configurations in which we know it won't be needed. - The number of pages allocated for interrupt stacks is now calculated correctly, where before we would wastefully allocate too much memory in some configurations. - The ath79 platform migrates to devicetree. - The bcm47xx platform sees fixes for the Buffalo WHR-G54S board. - The ingenic/jz4740 platform gains support for appended devicetrees. - The cavium_octeon, lantiq, loongson32 & sgi-ip27 platforms all see cleanups as do various pieces of core architecture code. -----BEGIN PGP SIGNATURE----- iIsEABYIADMWIQRgLjeFAZEXQzy86/s+p5+stXUA3QUCXH3BQxUccGF1bC5idXJ0 b25AbWlwcy5jb20ACgkQPqefrLV1AN1+4wD+Oh4JTfZN/NEOQMlrSkXxjEHqjX3u 1Y6CiiPCs+q2UnYBANb+ic+ZH5MnvJxxmcvlYI2q3rIh4b8TDriip4KMUTUP =Sw9X -----END PGP SIGNATURE----- Merge tag 'mips_5.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux Pull MIPS updates from Paul Burton: - Support for the MIPSr6 MemoryMapID register & Global INValidate TLB (GINVT) instructions, allowing for more efficient TLB maintenance when running on a CPU such as the I6500 that supports these. - Enable huge page support for MIPS64r6. - Optimize post-DMA cache sync by removing that code entirely for kernel configurations in which we know it won't be needed. - The number of pages allocated for interrupt stacks is now calculated correctly, where before we would wastefully allocate too much memory in some configurations. - The ath79 platform migrates to devicetree. - The bcm47xx platform sees fixes for the Buffalo WHR-G54S board. - The ingenic/jz4740 platform gains support for appended devicetrees. - The cavium_octeon, lantiq, loongson32 & sgi-ip27 platforms all see cleanups as do various pieces of core architecture code. * tag 'mips_5.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (66 commits) MIPS: lantiq: Remove separate GPHY Firmware loader MIPS: ingenic: Add support for appended devicetree MIPS: SGI-IP27: rework HUB interrupts MIPS: SGI-IP27: do boot CPU init later MIPS: SGI-IP27: do xtalk scanning later MIPS: SGI-IP27: use pr_info/pr_emerg and pr_cont to fix output MIPS: SGI-IP27: clean up bridge access and header files MIPS: SGI-IP27: get rid of volatile and hubreg_t MIPS: irq: Allocate accurate order pages for irq stack MIPS: dma-noncoherent: Remove bogus condition in dma_sync_phys() MIPS: eBPF: Remove REG_32BIT_ZERO_EX MIPS: eBPF: Always return sign extended 32b values MIPS: CM: Fix indentation MIPS: BCM47XX: Fix/improve Buffalo WHR-G54S support MIPS: OCTEON: program rx/tx-delay always from DT MIPS: OCTEON: delete board-specific link status MIPS: OCTEON: don't lie about interface type of CN3005 board MIPS: OCTEON: warn if deprecated link status is being used MIPS: OCTEON: add fixed-link nodes to in-kernel device tree MIPS: Delete unused flush_cache_sigtramp() ... |
||
|---|---|---|
| .. | ||
| arm | ||
| bus | ||
| clk | ||
| clock | ||
| display | ||
| dma | ||
| firmware/imx | ||
| gce | ||
| gpio | ||
| i2c | ||
| iio | ||
| input | ||
| interrupt-controller | ||
| leds | ||
| mailbox | ||
| media | ||
| memory | ||
| mfd | ||
| mips | ||
| mux | ||
| net | ||
| phy | ||
| pinctrl | ||
| power | ||
| pwm | ||
| regulator | ||
| reset | ||
| soc | ||
| sound | ||
| spmi | ||
| thermal | ||
| usb | ||