linux/arch/arm/mach-davinci/board-neuros-osd2.c

234 lines
6.4 KiB
C

/*
* Neuros Technologies OSD2 board support
*
* Modified from original 644X-EVM board support.
* 2008 (c) Neuros Technology, LLC.
* 2009 (c) Jorge Luis Zapata Muga <jorgeluis.zapata@gmail.com>
* 2009 (c) Andrey A. Porodko <Andrey.Porodko@gmail.com>
*
* The Neuros OSD 2.0 is the hardware component of the Neuros Open
* Internet Television Platform. Hardware is very close to TI
* DM644X-EVM board. It has:
* DM6446M02 module with 256MB NAND, 256MB RAM, TLV320AIC32 AIC,
* USB, Ethernet, SD/MMC, UART, THS8200, TVP7000 for video.
* Additionally realtime clock, IR remote control receiver,
* IR Blaster based on MSP430 (firmware although is different
* from used in DM644X-EVM), internal ATA-6 3.5” HDD drive
* with PATA interface, two muxed red-green leds.
*
* For more information please refer to
* http://wiki.neurostechnology.com/index.php/OSD_2.0_HD
*
* This file is licensed under the terms of the GNU General Public
* License version 2. This program is licensed "as is" without any
* warranty of any kind, whether express or implied.
*/
#include <linux/platform_device.h>
#include <linux/gpio.h>
#include <linux/mtd/partitions.h>
#include <linux/platform_data/gpio-davinci.h>
#include <linux/platform_data/i2c-davinci.h>
#include <linux/platform_data/mmc-davinci.h>
#include <linux/platform_data/mtd-davinci.h>
#include <linux/platform_data/usb-davinci.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <mach/common.h>
#include <mach/serial.h>
#include <mach/mux.h>
#include "davinci.h"
#define NEUROS_OSD2_PHY_ID "davinci_mdio-0:01"
#define LXT971_PHY_ID 0x001378e2
#define LXT971_PHY_MASK 0xfffffff0
#define NTOSD2_AUDIOSOC_I2C_ADDR 0x18
#define NTOSD2_MSP430_I2C_ADDR 0x59
#define NTOSD2_MSP430_IRQ 2
/* Neuros OSD2 has a Samsung 256 MByte NAND flash (Dev ID of 0xAA,
* 2048 blocks in the device, 64 pages per block, 2048 bytes per
* page.
*/
#define NAND_BLOCK_SIZE SZ_128K
static struct mtd_partition davinci_ntosd2_nandflash_partition[] = {
{
/* UBL (a few copies) plus U-Boot */
.name = "bootloader",
.offset = 0,
.size = 15 * NAND_BLOCK_SIZE,
.mask_flags = MTD_WRITEABLE, /* force read-only */
}, {
/* U-Boot environment */
.name = "params",
.offset = MTDPART_OFS_APPEND,
.size = 1 * NAND_BLOCK_SIZE,
.mask_flags = 0,
}, {
/* Kernel */
.name = "kernel",
.offset = MTDPART_OFS_APPEND,
.size = SZ_4M,
.mask_flags = 0,
}, {
/* File System */
.name = "filesystem",
.offset = MTDPART_OFS_APPEND,
.size = MTDPART_SIZ_FULL,
.mask_flags = 0,
}
/* A few blocks at end hold a flash Bad Block Table. */
};
static struct davinci_nand_pdata davinci_ntosd2_nandflash_data = {
.parts = davinci_ntosd2_nandflash_partition,
.nr_parts = ARRAY_SIZE(davinci_ntosd2_nandflash_partition),
.ecc_mode = NAND_ECC_HW,
.ecc_bits = 1,
.bbt_options = NAND_BBT_USE_FLASH,
};
static struct resource davinci_ntosd2_nandflash_resource[] = {
{
.start = DM644X_ASYNC_EMIF_DATA_CE0_BASE,
.end = DM644X_ASYNC_EMIF_DATA_CE0_BASE + SZ_16M - 1,
.flags = IORESOURCE_MEM,
}, {
.start = DM644X_ASYNC_EMIF_CONTROL_BASE,
.end = DM644X_ASYNC_EMIF_CONTROL_BASE + SZ_4K - 1,
.flags = IORESOURCE_MEM,
},
};
static struct platform_device davinci_ntosd2_nandflash_device = {
.name = "davinci_nand",
.id = 0,
.dev = {
.platform_data = &davinci_ntosd2_nandflash_data,
},
.num_resources = ARRAY_SIZE(davinci_ntosd2_nandflash_resource),
.resource = davinci_ntosd2_nandflash_resource,
};
static u64 davinci_fb_dma_mask = DMA_BIT_MASK(32);
static struct platform_device davinci_fb_device = {
.name = "davincifb",
.id = -1,
.dev = {
.dma_mask = &davinci_fb_dma_mask,
.coherent_dma_mask = DMA_BIT_MASK(32),
},
.num_resources = 0,
};
static struct gpio_led ntosd2_leds[] = {
{ .name = "led1_green", .gpio = GPIO(10), },
{ .name = "led1_red", .gpio = GPIO(11), },
{ .name = "led2_green", .gpio = GPIO(12), },
{ .name = "led2_red", .gpio = GPIO(13), },
};
static struct gpio_led_platform_data ntosd2_leds_data = {
.num_leds = ARRAY_SIZE(ntosd2_leds),
.leds = ntosd2_leds,
};
static struct platform_device ntosd2_leds_dev = {
.name = "leds-gpio",
.id = -1,
.dev = {
.platform_data = &ntosd2_leds_data,
},
};
static struct platform_device *davinci_ntosd2_devices[] __initdata = {
&davinci_fb_device,
&ntosd2_leds_dev,
};
static void __init davinci_ntosd2_map_io(void)
{
dm644x_init();
}
static struct davinci_mmc_config davinci_ntosd2_mmc_config = {
.wires = 4,
};
#define HAS_ATA IS_ENABLED(CONFIG_BLK_DEV_PALMCHIP_BK3710)
#define HAS_NAND IS_ENABLED(CONFIG_MTD_NAND_DAVINCI)
static __init void davinci_ntosd2_init(void)
{
int ret;
struct clk *aemif_clk;
struct davinci_soc_info *soc_info = &davinci_soc_info;
ret = dm644x_gpio_register();
if (ret)
pr_warn("%s: GPIO init failed: %d\n", __func__, ret);
aemif_clk = clk_get(NULL, "aemif");
clk_prepare_enable(aemif_clk);
if (HAS_ATA) {
if (HAS_NAND)
pr_warn("WARNING: both IDE and Flash are enabled, but they share AEMIF pins\n"
"\tDisable IDE for NAND/NOR support\n");
davinci_init_ide();
} else if (HAS_NAND) {
davinci_cfg_reg(DM644X_HPIEN_DISABLE);
davinci_cfg_reg(DM644X_ATAEN_DISABLE);
/* only one device will be jumpered and detected */
if (HAS_NAND)
platform_device_register(
&davinci_ntosd2_nandflash_device);
}
platform_add_devices(davinci_ntosd2_devices,
ARRAY_SIZE(davinci_ntosd2_devices));
davinci_serial_init(dm644x_serial_device);
dm644x_init_asp();
soc_info->emac_pdata->phy_id = NEUROS_OSD2_PHY_ID;
davinci_setup_usb(1000, 8);
/*
* Mux the pins to be GPIOs, VLYNQEN is already done at startup.
* The AEAWx are five new AEAW pins that can be muxed by separately.
* They are a bitmask for GPIO management. According TI
* documentation (http://www.ti.com/lit/gpn/tms320dm6446) to employ
* gpio(10,11,12,13) for leds any combination of bits works except
* four last. So we are to reset all five.
*/
davinci_cfg_reg(DM644X_AEAW0);
davinci_cfg_reg(DM644X_AEAW1);
davinci_cfg_reg(DM644X_AEAW2);
davinci_cfg_reg(DM644X_AEAW3);
davinci_cfg_reg(DM644X_AEAW4);
davinci_setup_mmc(0, &davinci_ntosd2_mmc_config);
}
MACHINE_START(NEUROS_OSD2, "Neuros OSD2")
/* Maintainer: Neuros Technologies <neuros@groups.google.com> */
.atag_offset = 0x100,
.map_io = davinci_ntosd2_map_io,
.init_irq = davinci_irq_init,
.init_time = davinci_timer_init,
.init_machine = davinci_ntosd2_init,
.init_late = davinci_init_late,
.dma_zone_size = SZ_128M,
.restart = davinci_restart,
MACHINE_END