143 lines
3.4 KiB
C
143 lines
3.4 KiB
C
/*
|
|
* timberdale.h timberdale FPGA MFD driver defines
|
|
* Copyright (c) 2009 Intel Corporation
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License version 2 as
|
|
* published by the Free Software Foundation.
|
|
*
|
|
* This program is distributed in the hope that it will be useful,
|
|
* but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
* GNU General Public License for more details.
|
|
*
|
|
* You should have received a copy of the GNU General Public License
|
|
* along with this program; if not, write to the Free Software
|
|
* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
|
|
*/
|
|
|
|
/* Supports:
|
|
* Timberdale FPGA
|
|
*/
|
|
|
|
#ifndef MFD_TIMBERDALE_H
|
|
#define MFD_TIMBERDALE_H
|
|
|
|
#define DRV_VERSION "0.3"
|
|
|
|
/* This driver only support versions >= 3.8 and < 4.0 */
|
|
#define TIMB_SUPPORTED_MAJOR 3
|
|
|
|
/* This driver only support minor >= 8 */
|
|
#define TIMB_REQUIRED_MINOR 8
|
|
|
|
/* Registers of the control area */
|
|
#define TIMB_REV_MAJOR 0x00
|
|
#define TIMB_REV_MINOR 0x04
|
|
#define TIMB_HW_CONFIG 0x08
|
|
#define TIMB_SW_RST 0x40
|
|
|
|
/* bits in the TIMB_HW_CONFIG register */
|
|
#define TIMB_HW_CONFIG_SPI_8BIT 0x80
|
|
|
|
#define TIMB_HW_VER_MASK 0x0f
|
|
#define TIMB_HW_VER0 0x00
|
|
#define TIMB_HW_VER1 0x01
|
|
#define TIMB_HW_VER2 0x02
|
|
#define TIMB_HW_VER3 0x03
|
|
|
|
#define OCORESOFFSET 0x0
|
|
#define OCORESEND 0x1f
|
|
|
|
#define SPIOFFSET 0x80
|
|
#define SPIEND 0xff
|
|
|
|
#define UARTLITEOFFSET 0x100
|
|
#define UARTLITEEND 0x10f
|
|
|
|
#define RDSOFFSET 0x180
|
|
#define RDSEND 0x183
|
|
|
|
#define ETHOFFSET 0x300
|
|
#define ETHEND 0x3ff
|
|
|
|
#define GPIOOFFSET 0x400
|
|
#define GPIOEND 0x7ff
|
|
|
|
#define CHIPCTLOFFSET 0x800
|
|
#define CHIPCTLEND 0x8ff
|
|
#define CHIPCTLSIZE (CHIPCTLEND - CHIPCTLOFFSET + 1)
|
|
|
|
#define INTCOFFSET 0xc00
|
|
#define INTCEND 0xfff
|
|
#define INTCSIZE (INTCEND - INTCOFFSET)
|
|
|
|
#define MOSTOFFSET 0x1000
|
|
#define MOSTEND 0x13ff
|
|
|
|
#define UARTOFFSET 0x1400
|
|
#define UARTEND 0x17ff
|
|
|
|
#define XIICOFFSET 0x1800
|
|
#define XIICEND 0x19ff
|
|
|
|
#define I2SOFFSET 0x1C00
|
|
#define I2SEND 0x1fff
|
|
|
|
#define LOGIWOFFSET 0x30000
|
|
#define LOGIWEND 0x37fff
|
|
|
|
#define MLCOREOFFSET 0x40000
|
|
#define MLCOREEND 0x43fff
|
|
|
|
#define DMAOFFSET 0x01000000
|
|
#define DMAEND 0x013fffff
|
|
|
|
/* SDHC0 is placed in PCI bar 1 */
|
|
#define SDHC0OFFSET 0x00
|
|
#define SDHC0END 0xff
|
|
|
|
/* SDHC1 is placed in PCI bar 2 */
|
|
#define SDHC1OFFSET 0x00
|
|
#define SDHC1END 0xff
|
|
|
|
#define PCI_VENDOR_ID_TIMB 0x10ee
|
|
#define PCI_DEVICE_ID_TIMB 0xa123
|
|
|
|
#define IRQ_TIMBERDALE_INIC 0
|
|
#define IRQ_TIMBERDALE_MLB 1
|
|
#define IRQ_TIMBERDALE_GPIO 2
|
|
#define IRQ_TIMBERDALE_I2C 3
|
|
#define IRQ_TIMBERDALE_UART 4
|
|
#define IRQ_TIMBERDALE_DMA 5
|
|
#define IRQ_TIMBERDALE_I2S 6
|
|
#define IRQ_TIMBERDALE_TSC_INT 7
|
|
#define IRQ_TIMBERDALE_SDHC 8
|
|
#define IRQ_TIMBERDALE_ADV7180 9
|
|
#define IRQ_TIMBERDALE_ETHSW_IF 10
|
|
#define IRQ_TIMBERDALE_SPI 11
|
|
#define IRQ_TIMBERDALE_UARTLITE 12
|
|
#define IRQ_TIMBERDALE_MLCORE 13
|
|
#define IRQ_TIMBERDALE_MLCORE_BUF 14
|
|
#define IRQ_TIMBERDALE_RDS 15
|
|
#define TIMBERDALE_NR_IRQS 16
|
|
|
|
#define GPIO_PIN_ASCB 8
|
|
#define GPIO_PIN_INIC_RST 14
|
|
#define GPIO_PIN_BT_RST 15
|
|
#define GPIO_NR_PINS 16
|
|
|
|
/* DMA Channels */
|
|
#define DMA_UART_RX 0
|
|
#define DMA_UART_TX 1
|
|
#define DMA_MLB_RX 2
|
|
#define DMA_MLB_TX 3
|
|
#define DMA_VIDEO_RX 4
|
|
#define DMA_VIDEO_DROP 5
|
|
#define DMA_SDHCI_RX 6
|
|
#define DMA_SDHCI_TX 7
|
|
#define DMA_ETH_RX 8
|
|
#define DMA_ETH_TX 9
|
|
|
|
#endif
|