683a52a101
Here's the big tty/serial driver patchset for 3.18-rc1. Lots of little things in here, some good work from Peter Hurley on the tty core, and in lots of drivers. There are also lots of other driver updates in here as well, full details in the changelog below. All have been in the linux-next tree for a while. Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> -----BEGIN PGP SIGNATURE----- Version: GnuPG v2 iEYEABECAAYFAlQ0aDwACgkQMUfUDdst+ymueACeI1i2exlGaBBSVQuUK2Jmx8Uz nukAn3KPuvvx+MKfMMBRpK0DQCzTxv4P =dwv1 -----END PGP SIGNATURE----- Merge tag 'tty-3.18-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty Pull tty/serial driver updates from Greg KH: "Here's the big tty/serial driver patchset for 3.18-rc1. Lots of little things in here, some good work from Peter Hurley on the tty core, and in lots of drivers. There are also lots of other driver updates in here as well, full details in the changelogs. All have been in the linux-next tree for a while" * tag 'tty-3.18-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty: (99 commits) Revert "serial/core: Initialize the console pm state" tty: serial: 8250: use 32bit variable for rpm_tx_active tty: serial: msm: Add earlycon support serial/core: Initialize the console pm state serial: asc: Conditionally use readl_relaxed (COMPILE_TEST) serial: of-serial: add PM suspend/resume support m68k: AMIGA_BUILTIN_SERIAL should depend on TTY asm/uapi: Add definition of TIOC[SG]RS485 tty/metag_da: Add console_poll module parameter serial: 8250_pci: remove rts_n override from Baytrail quirk serial: cadence: Add generic earlycon support serial: imx: change the wait even to interruptiable serial: imx: terminate the RX DMA when the UART is suspending serial: imx: fix throttle/unthrottle callbacks for hardware assisted flow control serial: 8250: Add Quark X1000 to 8250_pci.c tty: omap-serial: pull out calculation from baud_is_mode16 tty: omap-serial: fix division by zero xen_hvc: no reason to write the type key on xenstore tty: serial: 8250_core: remove UART_IER_RDI in serial8250_stop_rx() tty: serial: 8250_core: use the ->line argument as a hint in serial8250_find_match_or_unused() ... |
||
|---|---|---|
| .. | ||
| 00-INDEX | ||
| README.cycladesZ | ||
| driver | ||
| moxa-smartio | ||
| n_gsm.txt | ||
| rocket.txt | ||
| serial-rs485.txt | ||
| tty.txt | ||
README.cycladesZ
The Cyclades-Z must have firmware loaded onto the card before it will
operate. This operation should be performed during system startup,
The firmware, loader program and the latest device driver code are
available from Cyclades at
ftp://ftp.cyclades.com/pub/cyclades/cyclades-z/linux/