linux/Documentation/devicetree/bindings/gpio/nvidia,tegra20-gpio.txt

41 lines
1.3 KiB
Plaintext

NVIDIA Tegra GPIO controller
Required properties:
- compatible : "nvidia,tegra<chip>-gpio"
- reg : Physical base address and length of the controller's registers.
- interrupts : The interrupt outputs from the controller. For Tegra20,
there should be 7 interrupts specified, and for Tegra30, there should
be 8 interrupts specified.
- #gpio-cells : Should be two. The first cell is the pin number and the
second cell is used to specify optional parameters:
- bit 0 specifies polarity (0 for normal, 1 for inverted)
- gpio-controller : Marks the device node as a GPIO controller.
- #interrupt-cells : Should be 2.
The first cell is the GPIO number.
The second cell is used to specify flags:
bits[3:0] trigger type and level flags:
1 = low-to-high edge triggered.
2 = high-to-low edge triggered.
4 = active high level-sensitive.
8 = active low level-sensitive.
Valid combinations are 1, 2, 3, 4, 8.
- interrupt-controller : Marks the device node as an interrupt controller.
Example:
gpio: gpio@6000d000 {
compatible = "nvidia,tegra20-gpio";
reg = < 0x6000d000 0x1000 >;
interrupts = < 0 32 0x04
0 33 0x04
0 34 0x04
0 35 0x04
0 55 0x04
0 87 0x04
0 89 0x04 >;
#gpio-cells = <2>;
gpio-controller;
#interrupt-cells = <2>;
interrupt-controller;
};