linux/arch/arm/mach-zynq/timer.c

299 lines
8.8 KiB
C

/*
* This file contains driver for the Xilinx PS Timer Counter IP.
*
* Copyright (C) 2011 Xilinx
*
* based on arch/mips/kernel/time.c timer driver
*
* This software is licensed under the terms of the GNU General Public
* License version 2, as published by the Free Software Foundation, and
* may be copied, distributed, and modified under those terms.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/interrupt.h>
#include <linux/irq.h>
#include <linux/types.h>
#include <linux/clocksource.h>
#include <linux/clockchips.h>
#include <linux/io.h>
#include <asm/mach/time.h>
#include <mach/zynq_soc.h>
#include "common.h"
#define IRQ_TIMERCOUNTER0 42
/*
* This driver configures the 2 16-bit count-up timers as follows:
*
* T1: Timer 1, clocksource for generic timekeeping
* T2: Timer 2, clockevent source for hrtimers
* T3: Timer 3, <unused>
*
* The input frequency to the timer module for emulation is 2.5MHz which is
* common to all the timer channels (T1, T2, and T3). With a pre-scaler of 32,
* the timers are clocked at 78.125KHz (12.8 us resolution).
*
* The input frequency to the timer module in silicon will be 200MHz. With the
* pre-scaler of 32, the timers are clocked at 6.25MHz (160ns resolution).
*/
#define XTTCPSS_CLOCKSOURCE 0 /* Timer 1 as a generic timekeeping */
#define XTTCPSS_CLOCKEVENT 1 /* Timer 2 as a clock event */
#define XTTCPSS_TIMER_BASE TTC0_BASE
#define XTTCPCC_EVENT_TIMER_IRQ (IRQ_TIMERCOUNTER0 + 1)
/*
* Timer Register Offset Definitions of Timer 1, Increment base address by 4
* and use same offsets for Timer 2
*/
#define XTTCPSS_CLK_CNTRL_OFFSET 0x00 /* Clock Control Reg, RW */
#define XTTCPSS_CNT_CNTRL_OFFSET 0x0C /* Counter Control Reg, RW */
#define XTTCPSS_COUNT_VAL_OFFSET 0x18 /* Counter Value Reg, RO */
#define XTTCPSS_INTR_VAL_OFFSET 0x24 /* Interval Count Reg, RW */
#define XTTCPSS_MATCH_1_OFFSET 0x30 /* Match 1 Value Reg, RW */
#define XTTCPSS_MATCH_2_OFFSET 0x3C /* Match 2 Value Reg, RW */
#define XTTCPSS_MATCH_3_OFFSET 0x48 /* Match 3 Value Reg, RW */
#define XTTCPSS_ISR_OFFSET 0x54 /* Interrupt Status Reg, RO */
#define XTTCPSS_IER_OFFSET 0x60 /* Interrupt Enable Reg, RW */
#define XTTCPSS_CNT_CNTRL_DISABLE_MASK 0x1
/* Setup the timers to use pre-scaling */
#define TIMER_RATE (PERIPHERAL_CLOCK_RATE / 32)
/**
* struct xttcpss_timer - This definition defines local timer structure
*
* @base_addr: Base address of timer
**/
struct xttcpss_timer {
void __iomem *base_addr;
};
static struct xttcpss_timer timers[2];
static struct clock_event_device xttcpss_clockevent;
/**
* xttcpss_set_interval - Set the timer interval value
*
* @timer: Pointer to the timer instance
* @cycles: Timer interval ticks
**/
static void xttcpss_set_interval(struct xttcpss_timer *timer,
unsigned long cycles)
{
u32 ctrl_reg;
/* Disable the counter, set the counter value and re-enable counter */
ctrl_reg = __raw_readl(timer->base_addr + XTTCPSS_CNT_CNTRL_OFFSET);
ctrl_reg |= XTTCPSS_CNT_CNTRL_DISABLE_MASK;
__raw_writel(ctrl_reg, timer->base_addr + XTTCPSS_CNT_CNTRL_OFFSET);
__raw_writel(cycles, timer->base_addr + XTTCPSS_INTR_VAL_OFFSET);
/* Reset the counter (0x10) so that it starts from 0, one-shot
mode makes this needed for timing to be right. */
ctrl_reg |= 0x10;
ctrl_reg &= ~XTTCPSS_CNT_CNTRL_DISABLE_MASK;
__raw_writel(ctrl_reg, timer->base_addr + XTTCPSS_CNT_CNTRL_OFFSET);
}
/**
* xttcpss_clock_event_interrupt - Clock event timer interrupt handler
*
* @irq: IRQ number of the Timer
* @dev_id: void pointer to the xttcpss_timer instance
*
* returns: Always IRQ_HANDLED - success
**/
static irqreturn_t xttcpss_clock_event_interrupt(int irq, void *dev_id)
{
struct clock_event_device *evt = &xttcpss_clockevent;
struct xttcpss_timer *timer = dev_id;
/* Acknowledge the interrupt and call event handler */
__raw_writel(__raw_readl(timer->base_addr + XTTCPSS_ISR_OFFSET),
timer->base_addr + XTTCPSS_ISR_OFFSET);
evt->event_handler(evt);
return IRQ_HANDLED;
}
static struct irqaction event_timer_irq = {
.name = "xttcpss clockevent",
.flags = IRQF_DISABLED | IRQF_TIMER,
.handler = xttcpss_clock_event_interrupt,
};
/**
* xttcpss_timer_hardware_init - Initialize the timer hardware
*
* Initialize the hardware to start the clock source, get the clock
* event timer ready to use, and hook up the interrupt.
**/
static void __init xttcpss_timer_hardware_init(void)
{
/* Setup the clock source counter to be an incrementing counter
* with no interrupt and it rolls over at 0xFFFF. Pre-scale
it by 32 also. Let it start running now.
*/
timers[XTTCPSS_CLOCKSOURCE].base_addr = XTTCPSS_TIMER_BASE;
__raw_writel(0x0, timers[XTTCPSS_CLOCKSOURCE].base_addr +
XTTCPSS_IER_OFFSET);
__raw_writel(0x9, timers[XTTCPSS_CLOCKSOURCE].base_addr +
XTTCPSS_CLK_CNTRL_OFFSET);
__raw_writel(0x10, timers[XTTCPSS_CLOCKSOURCE].base_addr +
XTTCPSS_CNT_CNTRL_OFFSET);
/* Setup the clock event timer to be an interval timer which
* is prescaled by 32 using the interval interrupt. Leave it
* disabled for now.
*/
timers[XTTCPSS_CLOCKEVENT].base_addr = XTTCPSS_TIMER_BASE + 4;
__raw_writel(0x23, timers[XTTCPSS_CLOCKEVENT].base_addr +
XTTCPSS_CNT_CNTRL_OFFSET);
__raw_writel(0x9, timers[XTTCPSS_CLOCKEVENT].base_addr +
XTTCPSS_CLK_CNTRL_OFFSET);
__raw_writel(0x1, timers[XTTCPSS_CLOCKEVENT].base_addr +
XTTCPSS_IER_OFFSET);
/* Setup IRQ the clock event timer */
event_timer_irq.dev_id = &timers[XTTCPSS_CLOCKEVENT];
setup_irq(XTTCPCC_EVENT_TIMER_IRQ, &event_timer_irq);
}
/**
* __raw_readl_cycles - Reads the timer counter register
*
* returns: Current timer counter register value
**/
static cycle_t __raw_readl_cycles(struct clocksource *cs)
{
struct xttcpss_timer *timer = &timers[XTTCPSS_CLOCKSOURCE];
return (cycle_t)__raw_readl(timer->base_addr +
XTTCPSS_COUNT_VAL_OFFSET);
}
/*
* Instantiate and initialize the clock source structure
*/
static struct clocksource clocksource_xttcpss = {
.name = "xttcpss_timer1",
.rating = 200, /* Reasonable clock source */
.read = __raw_readl_cycles,
.mask = CLOCKSOURCE_MASK(16),
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
/**
* xttcpss_set_next_event - Sets the time interval for next event
*
* @cycles: Timer interval ticks
* @evt: Address of clock event instance
*
* returns: Always 0 - success
**/
static int xttcpss_set_next_event(unsigned long cycles,
struct clock_event_device *evt)
{
struct xttcpss_timer *timer = &timers[XTTCPSS_CLOCKEVENT];
xttcpss_set_interval(timer, cycles);
return 0;
}
/**
* xttcpss_set_mode - Sets the mode of timer
*
* @mode: Mode to be set
* @evt: Address of clock event instance
**/
static void xttcpss_set_mode(enum clock_event_mode mode,
struct clock_event_device *evt)
{
struct xttcpss_timer *timer = &timers[XTTCPSS_CLOCKEVENT];
u32 ctrl_reg;
switch (mode) {
case CLOCK_EVT_MODE_PERIODIC:
xttcpss_set_interval(timer, TIMER_RATE / HZ);
break;
case CLOCK_EVT_MODE_ONESHOT:
case CLOCK_EVT_MODE_UNUSED:
case CLOCK_EVT_MODE_SHUTDOWN:
ctrl_reg = __raw_readl(timer->base_addr +
XTTCPSS_CNT_CNTRL_OFFSET);
ctrl_reg |= XTTCPSS_CNT_CNTRL_DISABLE_MASK;
__raw_writel(ctrl_reg,
timer->base_addr + XTTCPSS_CNT_CNTRL_OFFSET);
break;
case CLOCK_EVT_MODE_RESUME:
ctrl_reg = __raw_readl(timer->base_addr +
XTTCPSS_CNT_CNTRL_OFFSET);
ctrl_reg &= ~XTTCPSS_CNT_CNTRL_DISABLE_MASK;
__raw_writel(ctrl_reg,
timer->base_addr + XTTCPSS_CNT_CNTRL_OFFSET);
break;
}
}
/*
* Instantiate and initialize the clock event structure
*/
static struct clock_event_device xttcpss_clockevent = {
.name = "xttcpss_timer2",
.features = CLOCK_EVT_FEAT_PERIODIC | CLOCK_EVT_FEAT_ONESHOT,
.set_next_event = xttcpss_set_next_event,
.set_mode = xttcpss_set_mode,
.rating = 200,
};
/**
* xttcpss_timer_init - Initialize the timer
*
* Initializes the timer hardware and register the clock source and clock event
* timers with Linux kernal timer framework
**/
static void __init xttcpss_timer_init(void)
{
xttcpss_timer_hardware_init();
clocksource_register_hz(&clocksource_xttcpss, TIMER_RATE);
/* Calculate the parameters to allow the clockevent to operate using
integer math
*/
clockevents_calc_mult_shift(&xttcpss_clockevent, TIMER_RATE, 4);
xttcpss_clockevent.max_delta_ns =
clockevent_delta2ns(0xfffe, &xttcpss_clockevent);
xttcpss_clockevent.min_delta_ns =
clockevent_delta2ns(1, &xttcpss_clockevent);
/* Indicate that clock event is on 1st CPU as SMP boot needs it */
xttcpss_clockevent.cpumask = cpumask_of(0);
clockevents_register_device(&xttcpss_clockevent);
}
/*
* Instantiate and initialize the system timer structure
*/
struct sys_timer xttcpss_sys_timer = {
.init = xttcpss_timer_init,
};