So far we were using fs_initcall. It was (and still is) needed because struct bus_type has to be registered early. However main bus initialization has to happen later as it requires SPROM which depends on NVRAM which depends on mtd. Solve it by using fs_initcall only for bus_register call and module_init for the rest. It affects bcma only when built-in obviously. This was tested with BCM4706 and BCM5357C0 (BCM47XX), BCM4708A0 (ARCH_BCM_5301X) and BCM43225 (PCIe card with bcma as module). Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Kalle Valo <kvalo@codeaurora.org> |
||
---|---|---|
.. | ||
Kconfig | ||
Makefile | ||
README | ||
TODO | ||
bcma_private.h | ||
core.c | ||
driver_chipcommon.c | ||
driver_chipcommon_b.c | ||
driver_chipcommon_nflash.c | ||
driver_chipcommon_pmu.c | ||
driver_chipcommon_sflash.c | ||
driver_gmac_cmn.c | ||
driver_gpio.c | ||
driver_mips.c | ||
driver_pci.c | ||
driver_pci_host.c | ||
driver_pcie2.c | ||
host_pci.c | ||
host_soc.c | ||
main.c | ||
scan.c | ||
scan.h | ||
sprom.c |
README
Broadcom introduced new bus as replacement for older SSB. It is based on AMBA, however from programming point of view there is nothing AMBA specific we use. Standard AMBA drivers are platform specific, have hardcoded addresses and use AMBA standard fields like CID and PID. In case of Broadcom's cards every device consists of: 1) Broadcom specific AMBA device. It is put on AMBA bus, but can not be treated as standard AMBA device. Reading it's CID or PID can cause machine lockup. 2) AMBA standard devices called ports or wrappers. They have CIDs (AMBA_CID) and PIDs (0x103BB369), but we do not use that info for anything. One of that devices is used for managing Broadcom specific core. Addresses of AMBA devices are not hardcoded in driver and have to be read from EPROM. In this situation we decided to introduce separated bus. It can contain up to 16 devices identified by Broadcom specific fields: manufacturer, id, revision and class.