The temperature and voltage limits currently set on these boards are too conservative and will cause the driver to stop the net device erroneously in some systems. Based on a review of the chip datasheets and advice from the designer of these boards: - Raise the maximum board temperatures to the specified maximum ambient temperatures for their PHYs plus the expected temperature bias of the board - Raise the maximum controller temperature to 90 degrees - Lower the minimum temperatures to 0 degrees - Widen the voltage tolerances to at least +/- 10% Signed-off-by: Ben Hutchings <bhutchings@solarflare.com> Signed-off-by: David S. Miller <davem@davemloft.net> |
||
---|---|---|
.. | ||
Kconfig | ||
Makefile | ||
bitfield.h | ||
efx.c | ||
efx.h | ||
enum.h | ||
ethtool.c | ||
falcon.c | ||
falcon_boards.c | ||
falcon_gmac.c | ||
falcon_xmac.c | ||
io.h | ||
mac.h | ||
mcdi.c | ||
mcdi.h | ||
mcdi_mac.c | ||
mcdi_pcol.h | ||
mcdi_phy.c | ||
mdio_10g.c | ||
mdio_10g.h | ||
mtd.c | ||
net_driver.h | ||
nic.c | ||
nic.h | ||
phy.h | ||
qt202x_phy.c | ||
regs.h | ||
rx.c | ||
selftest.c | ||
selftest.h | ||
siena.c | ||
spi.h | ||
tenxpress.c | ||
tx.c | ||
workarounds.h |