ed14e1c2f4
Correct problem introduced during the board refactoring where the XCLK frequency would get zero'd out. The sequence of events was as follows: em28xx_pre_card_setup() called em28xx_set_model() em28xx_set_model() would memcpy to dev->board configuration em28xx_pre_card_setup() would set the dev->board.xclk if not set em28xx_pre_card_setup() would set the XCLK register based on dev->board.xclk ... em28xx_card_setup() would call em28xx_set_model() em28xx_set_model() would memcpy to dev->board configuration (clearing out value of dev->board.xclk set in em28xx_pre_card_setup) ... em28xx_audio_analog_set() sets the XCLK register based on dev->board.xclk (which now contains zero) The change sets the default XCLK and I2C Clock fields in the board definition inside of em28xx_set_model() so that subsequent calls do not cause the values to be overwritten. Signed-off-by: Devin Heitmueller <dheitmueller@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com> |
||
---|---|---|
.. | ||
accessibility | ||
acpi | ||
amba | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
block | ||
bluetooth | ||
cdrom | ||
char | ||
clocksource | ||
connector | ||
cpufreq | ||
cpuidle | ||
crypto | ||
dca | ||
dio | ||
dma | ||
edac | ||
eisa | ||
firewire | ||
firmware | ||
gpio | ||
gpu | ||
hid | ||
hwmon | ||
i2c | ||
ide | ||
idle | ||
ieee1394 | ||
infiniband | ||
input | ||
isdn | ||
leds | ||
lguest | ||
macintosh | ||
mca | ||
md | ||
media | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
mtd | ||
net | ||
nubus | ||
of | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
pnp | ||
power | ||
ps3 | ||
rapidio | ||
regulator | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
serial | ||
sh | ||
sn | ||
spi | ||
ssb | ||
staging | ||
tc | ||
telephony | ||
thermal | ||
uio | ||
usb | ||
uwb | ||
video | ||
virtio | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | ||
Makefile |