linux/Documentation/devicetree/bindings/mtd/nxp-spifi.txt

59 lines
1.8 KiB
Plaintext

* NXP SPI Flash Interface (SPIFI)
NXP SPIFI is a specialized SPI interface for serial Flash devices.
It supports one Flash device with 1-, 2- and 4-bits width in SPI
mode 0 or 3. The controller operates in either command or memory
mode. In memory mode the Flash is accessible from the CPU as
normal memory.
Required properties:
- compatible : Should be "nxp,lpc1773-spifi"
- reg : the first contains the register location and length,
the second contains the memory mapping address and length
- reg-names: Should contain the reg names "spifi" and "flash"
- interrupts : Should contain the interrupt for the device
- clocks : The clocks needed by the SPIFI controller
- clock-names : Should contain the clock names "spifi" and "reg"
Optional properties:
- resets : phandle + reset specifier
The SPI Flash must be a child of the SPIFI node and must have a
compatible property as specified in bindings/mtd/jedec,spi-nor.txt
Optionally it can also contain the following properties.
- spi-cpol : Controller only supports mode 0 and 3 so either
both spi-cpol and spi-cpha should be present or
none of them
- spi-cpha : See above
- spi-rx-bus-width : Used to select how many pins that are used
for input on the controller
See bindings/spi/spi-bus.txt for more information.
Example:
spifi: spifi@40003000 {
compatible = "nxp,lpc1773-spifi";
reg = <0x40003000 0x1000>, <0x14000000 0x4000000>;
reg-names = "spifi", "flash";
interrupts = <30>;
clocks = <&ccu1 CLK_SPIFI>, <&ccu1 CLK_CPU_SPIFI>;
clock-names = "spifi", "reg";
resets = <&rgu 53>;
flash@0 {
compatible = "jedec,spi-nor";
spi-cpol;
spi-cpha;
spi-rx-bus-width = <4>;
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "data";
reg = <0 0x200000>;
};
};
};