hw/mips/malta: Set PIIX4 IRQ routes in embedded bootloader

Linux kernel expects the northbridge & southbridge chipsets
configured by the BIOS firmware. We emulate that by writing
a tiny bootloader code in write_bootloader().

Upon introduction in commit 5c2b87e34d ("PIIX4 support"),
the PIIX4 configuration space included values specific to
the Malta board.

Set the Malta-specific IRQ routing values in the embedded
bootloader, so the next commit can remove the Malta specific
bits from the PIIX4 PCI-ISA bridge and make it generic
(matching the real hardware).

Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Michael S. Tsirkin <mst@redhat.com>
Message-Id: <20221027204720.33611-3-philmd@linaro.org>
This commit is contained in:
Philippe Mathieu-Daudé 2022-10-26 01:54:46 +02:00
parent 6dd92ce6c5
commit 1953dfa80e

View File

@ -621,6 +621,10 @@ static void network_init(PCIBus *pci_bus)
static void bl_setup_gt64120_jump_kernel(void **p, uint64_t run_addr,
uint64_t kernel_entry)
{
static const char pci_pins_cfg[PCI_NUM_PINS] = {
10, 10, 11, 11 /* PIIX IRQRC[A:D] */
};
/* Bus endianess is always reversed */
#if TARGET_BIG_ENDIAN
#define cpu_to_gt32 cpu_to_le32
@ -659,6 +663,20 @@ static void bl_setup_gt64120_jump_kernel(void **p, uint64_t run_addr,
#undef cpu_to_gt32
/*
* The PIIX ISA bridge is on PCI bus 0 dev 10 func 0.
* Load the PIIX IRQC[A:D] routing config address, then
* write routing configuration to the config data register.
*/
bl_gen_write_u32(p, /* GT_PCI0_CFGADDR */
cpu_mips_phys_to_kseg1(NULL, 0x1be00000 + 0xcf8),
tswap32((1 << 31) /* ConfigEn */
| PCI_BUILD_BDF(0, PIIX4_PCI_DEVFN) << 8
| PIIX_PIRQCA));
bl_gen_write_u32(p, /* GT_PCI0_CFGDATA */
cpu_mips_phys_to_kseg1(NULL, 0x1be00000 + 0xcfc),
tswap32(ldl_be_p(pci_pins_cfg)));
bl_gen_jump_kernel(p,
true, ENVP_VADDR - 64,
/*