migration: loosen recovery check when load vm

We were checking against -EIO, assuming that it will cover all IO
failures.  But actually it is not.  One example is that in
qemu_loadvm_section_start_full() we can have tons of places that will
return -EINVAL even if the error is caused by IO failures on the
network.

Let's loosen the recovery check logic here to cover all the error cases
happened by removing the explicit check against -EIO.  After all we
won't lose anything here if any other failure happened.

Reviewed-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Peter Xu <peterx@redhat.com>
Message-Id: <20180710091902.28780-3-peterx@redhat.com>
Signed-off-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
This commit is contained in:
Peter Xu 2018-07-10 17:18:54 +08:00 committed by Dr. David Alan Gilbert
parent 1aa8367861
commit fd037a656a
1 changed files with 6 additions and 10 deletions

View File

@ -2276,18 +2276,14 @@ out:
qemu_file_set_error(f, ret);
/*
* Detect whether it is:
*
* 1. postcopy running (after receiving all device data, which
* must be in POSTCOPY_INCOMING_RUNNING state. Note that
* POSTCOPY_INCOMING_LISTENING is still not enough, it's
* still receiving device states).
* 2. network failure (-EIO)
*
* If so, we try to wait for a recovery.
* If we are during an active postcopy, then we pause instead
* of bail out to at least keep the VM's dirty data. Note
* that POSTCOPY_INCOMING_LISTENING stage is still not enough,
* during which we're still receiving device states and we
* still haven't yet started the VM on destination.
*/
if (postcopy_state_get() == POSTCOPY_INCOMING_RUNNING &&
ret == -EIO && postcopy_pause_incoming(mis)) {
postcopy_pause_incoming(mis)) {
/* Reset f to point to the newly created channel */
f = mis->from_src_file;
goto retry;