The exception return address for nios2 is the instruction
after the one that was executing at the time of the exception.
We have so far implemented this by advancing the pc during the
process of raising the exception. It is perhaps a little less
confusing to do this advance in the translator (and helpers)
when raising the exception in the first place, so that we may
more closely match kernel sources.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <20220421151735.31996-58-richard.henderson@linaro.org>
When CRS = 0, we restore from estatus; otherwise from sstatus.
Update for the new CRS.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-56-richard.henderson@linaro.org>
Implement these out of line, so that tcg global temps
(aka the architectural registers) are synced back to
tcg storage as required. This makes sure that we get
the proper results when status.PRS == status.CRS.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-55-richard.henderson@linaro.org>
Indirect branches, plus eret and bret optionally raise
an exception when branching to a misaligned address.
The exception is required when an mmu is enabled, but
enable it always because the fallback behaviour is not
documented (though presumably it discards low bits).
For the purposes of the linux-user cpu loop, if EXCP_UNALIGN
(misaligned data) were to arrive, it would be treated the
same as EXCP_UNALIGND (misaligned destination). See the
!defined(CONFIG_NIOS2_ALIGNMENT_TRAP) block in kernel/traps.c.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-53-richard.henderson@linaro.org>
Division may (optionally) raise a division exception.
Since the linux kernel has been prepared for this for
some time, enable it by default.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-42-richard.henderson@linaro.org>
Create an array of masks which detail the writable and readonly
bits for each control register. Apply them when writing to
control registers, including the write to status during eret.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <20220421151735.31996-38-richard.henderson@linaro.org>
Place the control registers into their own array, env->ctrl[].
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-23-richard.henderson@linaro.org>
The implementation of eret will become much more complex
with the introduction of shadow registers.
[rth: Split out of a larger patch for shadow register sets.
Directly exit to the cpu loop from the helper.]
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Amir Gonnen <amir.gonnen@neuroblade.ai>
Message-Id: <20220303153906.2024748-3-amir.gonnen@neuroblade.ai>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20220421151735.31996-18-richard.henderson@linaro.org>
Previously, we would avoid setting CPU_INTERRUPT_HARD when interrupts
are disabled at a particular point in time, instead queuing the value
into cpu->irq_pending. This is more complicated than required.
Instead, set CPU_INTERRUPT_HARD any time there is a pending interrupt,
and exclusively check for interrupts disabled in nios2_cpu_exec_interrupt.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Create three separate functions for the three separate registers.
Avoid extra dispatch through op_helper.c.
Dispatch to the correct function in translation.
Clean up the ifdefs in wrctl.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
This functionality can be had via plugins, if desired.
In the meantime, it is unused code.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The function nios2_check_interrupts)() looks only at CPU-internal
state; it belongs in target/nios2, not hw/nios2. Move it into the
same file as its only caller, so it can just be local to that file.
This removes the only remaining code from cpu_pic.c, so we can delete
that file entirely.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Message-id: 20201129174022.26530-3-peter.maydell@linaro.org
Reviewed-by: Wentong Wu <wentong.wu@intel.com>
Tested-by: Wentong Wu <wentong.wu@intel.com>
Now that we have both ArchCPU and CPUArchState, we can define
this generically instead of via macro in each target's cpu.h.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Acked-by: Alistair Francis <alistair.francis@wdc.com>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
applied using ./scripts/clean-includes
Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Michael Tokarev <mjt@tls.msk.ru>
Add support for emulating Altera NiosII R1 architecture into qemu.
This patch is based on previous work by Chris Wulff from 2012 and
updated to latest mainline QEMU.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Chris Wulff <crwulff@gmail.com>
Cc: Jeff Da Silva <jdasilva@altera.com>
Cc: Ley Foon Tan <lftan@altera.com>
Cc: Sandra Loosemore <sandra@codesourcery.com>
Cc: Yves Vandervennet <yvanderv@altera.com>
Cc: Alexander Graf <agraf@suse.de>
Message-Id: <20170118220146.489-3-marex@denx.de>
[rth: Remove tlb_flush from nios2_cpu_reset.]
Signed-off-by: Richard Henderson <rth@twiddle.net>
