This removes the hardcoded I2C address from the tests. The address
is passed via QOSGraphEdgeOptions to i2c_device_create and stored
in the QI2CDevice.
The i2c_send and i2c_recv functions, along with their wrappers,
therefore, can be changed to take a QI2CDevice rather than an
adapter/address pair.
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Provide *_init functions that populate an I2CAdapter struct without
allocating one, and make the existing *_create functions wrap them.
Because in the new setup *_create might return a pointer inside the
IMXI2C or OMAPI2C struct, create companion *_free functions to go
back to the outer pointer.
All this is temporary until allocation will be handled entirely by
qgraph.
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
receive_autoinc is relying on the LED state that is set by
send_and_receive. Stop doing that, because qgraph resets the
machine between tests.
Reviewed-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The functions to read/write 8-bit or 16-bit registers are the same
in tmp105 and pca9552 tests, and in fact they are a special case of
"read block"/"write block" functionality; read block in turn is used
in ds1338-test.
Move everything inside libqos-test, removing the duplication. Account
for the small differences by adding to tmp105-test.c the "read register
after writing" behavior that is specific to it.
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Specs are available here :
https://www.nxp.com/docs/en/application-note/AN264.pdf
This is a simple model supporting the basic registers for led and GPIO
mode. The device also supports two blinking rates but not the model
yet.
Signed-off-by: Cédric Le Goater <clg@kaod.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Message-id: 20180530064049.27976-7-clg@kaod.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
