Hyper-V TLFS allows for L0 and L1 hypervisors to collaborate on L2's
TLB flush hypercalls handling. With the correct setup, L2's TLB flush
hypercalls can be handled by L0 directly, without the need to exit to
L1.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20220525115949.1294004-6-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
KVM kind of supported "extended GVA ranges" (up to 4095 additional GFNs
per hypercall) since the implementation of Hyper-V PV TLB flush feature
(Linux-4.18) as regardless of the request, full TLB flush was always
performed. "Extended GVA ranges for TLB flush hypercalls" feature bit
wasn't exposed then. Now, as KVM gains support for fine-grained TLB
flush handling, exposing this feature starts making sense.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20220525115949.1294004-5-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Hyper-V specification allows to pass parameters for certain hypercalls
using XMM registers ("XMM Fast Hypercall Input"). When the feature is
in use, it allows for faster hypercalls processing as KVM can avoid
reading guest's memory.
KVM supports the feature since v5.14.
Rename HV_HYPERCALL_{PARAMS_XMM_AVAILABLE -> XMM_INPUT_AVAILABLE} to
comply with KVM.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20220525115949.1294004-4-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The newly introduced enlightenment allow L0 (KVM) and L1 (Hyper-V)
hypervisors to collaborate to avoid unnecessary updates to L2
MSR-Bitmap upon vmexits.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20220525115949.1294004-3-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Add all required definitions for hyperv synthetic debugger interface.
Signed-off-by: Jon Doron <arilou@gmail.com>
Reviewed-by: Emanuele Giuseppe Esposito <eesposit@redhat.com>
Message-Id: <20220216102500.692781-3-arilou@gmail.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
The enlightenment allows to use Hyper-V SynIC with hardware APICv/AVIC
enabled. Normally, Hyper-V SynIC disables these hardware features and
suggests the guest to use paravirtualized AutoEOI feature. Linux-4.15
gains support for conditional APICv/AVIC disablement, the feature
stays on until the guest tries to use AutoEOI feature with SynIC. With
'HV_DEPRECATING_AEOI_RECOMMENDED' bit exposed, modern enough Windows/
Hyper-V versions should follow the recommendation and not use the
(unwanted) feature.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20210902093530.345756-7-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
When Hyper-V SynIC is enabled, we may need to allow Windows guests to make
hypercalls (POST_MESSAGES/SIGNAL_EVENTS). No issue is currently observed
because KVM is very permissive, allowing these hypercalls regarding of
guest visible CPUid bits.
Reviewed-by: Eduardo Habkost <ehabkost@redhat.com>
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20210608120817.1325125-9-vkuznets@redhat.com>
Signed-off-by: Eduardo Habkost <ehabkost@redhat.com>
KVM doesn't fully support Hyper-V reenlightenment notifications on
migration. In particular, it doesn't support emulating TSC frequency
of the source host by trapping all TSC accesses so unless TSC scaling
is supported on the destination host and KVM_SET_TSC_KHZ succeeds, it
is unsafe to proceed with migration.
KVM_SET_TSC_KHZ is called from two sites: kvm_arch_init_vcpu() and
kvm_arch_put_registers(). The later (intentionally) doesn't propagate
errors allowing migrations to succeed even when TSC scaling is not
supported on the destination. This doesn't suit 're-enlightenment'
use-case as we have to guarantee that TSC frequency stays constant.
Require 'tsc-frequency=' command line option to be specified for successful
migration when re-enlightenment was enabled by the guest.
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
Message-Id: <20210319123801.1111090-1-vkuznets@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
