In my "build everything" tree, changing hw/hw.h triggers a recompile
of some 2600 out of 6600 objects (not counting tests and objects that
don't depend on qemu/osdep.h).
The previous commits have left only the declaration of hw_error() in
hw/hw.h. This permits dropping most of its inclusions. Touching it
now recompiles less than 200 objects.
Signed-off-by: Markus Armbruster <armbru@redhat.com>
Reviewed-by: Alistair Francis <alistair.francis@wdc.com>
Message-Id: <20190812052359.30071-19-armbru@redhat.com>
Reviewed-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Tested-by: Philippe Mathieu-Daudé <philmd@redhat.com>
A Xen PV frontend communicates its state to the PV backend by writing to
the 'state' key in the frontend area in xenstore. It is therefore
necessary for a XenDevice implementation to be notified whenever the
value of this key changes.
This patch adds code to do this as follows:
- an 'fd handler' is registered on the libxenstore handle which will be
triggered whenever a 'watch' event occurs
- primitives are added to xen-bus-helper to add or remove watch events
- a list of Notifier objects is added to XenBus to provide a mechanism
to call the appropriate 'watch handler' when its associated event
occurs
The xen-block implementation is extended with a 'frontend_changed' method,
which calls as-yet stub 'connect' and 'disconnect' functions when the
relevant frontend state transitions occur. A subsequent patch will supply
a full implementation for these functions.
Signed-off-by: Paul Durrant <paul.durrant@citrix.com>
Reviewed-by: Anthony Perard <anthony.perard@citrix.com>
Signed-off-by: Anthony PERARD <anthony.perard@citrix.com>
This patch adds a new source module, xen-bus-helper.c, which builds on
basic libxenstore primitives to provide functions to create (setting
permissions appropriately) and destroy xenstore areas, and functions to
'printf' and 'scanf' nodes therein. The main xen-bus code then uses
these primitives [1] to initialize and destroy the frontend and backend
areas for a XenDevice during realize and unrealize respectively.
The 'xen-block' implementation is extended with a 'get_name' method that
returns the VBD number. This number is required to 'name' the xenstore
areas.
NOTE: An exit handler is also added to make sure the xenstore areas are
cleaned up if QEMU terminates without devices being unrealized.
[1] The 'scanf' functions are actually not yet needed, but they will be
needed by code delivered in subsequent patches.
Signed-off-by: Paul Durrant <paul.durrant@citrix.com>
Reviewed-by: Anthony Perard <anthony.perard@citrix.com>
Signed-off-by: Anthony PERARD <anthony.perard@citrix.com>
