c759a790b6
Add a QOM bus for SD cards to plug in to. Note that since sd_enable() is used only by one board and there only as part of a broken implementation, we do not provide it in the SDBus API (but instead add a warning comment about the old function). Whoever converts OMAP and the nseries boards to QOM will need to either implement the card switch properly or move the enable hack into the OMAP MMC controller model. In the SDBus API, the old-style use of sd_set_cb to register some qemu_irqs for notification of card insertion and write-protect toggling is replaced with methods in the SDBusClass which the card calls on status changes and methods in the SDClass which the controller can call to find out the current status. The query methods will allow us to remove the abuse of the 'register irqs' API by controllers in their reset methods to trigger the card to tell them about the current status again. Signed-off-by: Peter Maydell <peter.maydell@linaro.org> Reviewed-by: Alistair Francis <alistair.francis@xilinx.com> Message-id: 1455646193-13238-5-git-send-email-peter.maydell@linaro.org
9 lines
274 B
Makefile
9 lines
274 B
Makefile
common-obj-$(CONFIG_PL181) += pl181.o
|
|
common-obj-$(CONFIG_SSI_SD) += ssi-sd.o
|
|
common-obj-$(CONFIG_SD) += sd.o core.o
|
|
common-obj-$(CONFIG_SDHCI) += sdhci.o
|
|
|
|
obj-$(CONFIG_MILKYMIST) += milkymist-memcard.o
|
|
obj-$(CONFIG_OMAP) += omap_mmc.o
|
|
obj-$(CONFIG_PXA2XX) += pxa2xx_mmci.o
|