924ed16386
Each controller on the ast2400 has a memory range on which it maps its flash module slaves. Each slave is assigned a memory segment for its mapping that can be changed at bootime with the Segment Address Register. This is not supported in the current implementation so we are using the defaults provided by the specs. Each SPI flash slave can then be accessed in two modes: Command and User. When in User mode, accesses to the memory segment of the slaves are translated in SPI transfers. When in Command mode, the HW generates the SPI commands automatically and the memory segment is accessed as if doing a MMIO. Other SPI controllers call that mode linear addressing mode. For this purpose, we are adding below each crontoller an array of structs gathering for each SPI flash module, a segment rank, a MemoryRegion to handle the memory accesses and the associated SPI slave device, which should be a m25p80. Only the User mode is supported for now but we are preparing ground for the Command mode. The framework is sufficient to support Linux. Signed-off-by: Cédric Le Goater <clg@kaod.org> Message-id: 1467138270-32481-8-git-send-email-clg@kaod.org [PMM: Use g_new0() rather than g_malloc0()] Reviewed-by: Peter Maydell <peter.maydell@linaro.org> Signed-off-by: Peter Maydell <peter.maydell@linaro.org> |
||
---|---|---|
.. | ||
Makefile.objs | ||
aspeed_smc.c | ||
imx_spi.c | ||
omap_spi.c | ||
pl022.c | ||
ssi.c | ||
xilinx_spi.c | ||
xilinx_spips.c |