rust/COMPILER_TESTS.md

85 lines
3.0 KiB
Markdown
Raw Normal View History

2015-09-12 17:02:01 +02:00
# Compiler Test Documentation
2015-10-13 15:44:11 +02:00
In the Rust project, we use a special set of commands embedded in
2015-09-12 17:02:01 +02:00
comments to test the Rust compiler. There are two groups of commands:
1. Header commands
2. Error info commands
Both types of commands are inside comments, but header commands should
be in a comment before any code.
## Summary of Error Info Commands
Error commands specify something about certain lines of the
program. They tell the test what kind of error and what message you
are expecting.
* `~`: Associates the following error level and message with the
current line
* `~|`: Associates the following error level and message with the same
line as the previous comment
* `~^`: Associates the following error level and message with the
previous line. Each caret (`^`) that you add adds a line to this, so
`~^^^^^^^` is seven lines up.
The error levels that you can have are:
2015-10-02 06:45:47 +02:00
2015-09-12 17:02:01 +02:00
1. `ERROR`
2. `WARNING`
3. `NOTE`
4. `HELP` and `SUGGESTION`*
\* **Note**: `SUGGESTION` must follow immediately after `HELP`.
2015-09-12 17:02:01 +02:00
## Summary of Header Commands
Header commands specify something about the entire test file as a
2015-09-12 17:02:01 +02:00
whole, instead of just a few lines inside the test.
* `ignore-X` where `X` is an architecture, OS or stage will ignore the test accordingly
* `ignore-pretty` will not compile the pretty-printed test (this is done to test the pretty-printer, but might not always work)
* `ignore-test` always ignores the test
* `ignore-lldb` and `ignore-gdb` will skip the debuginfo tests
* `min-{gdb,lldb}-version`
* `should-fail` indicates that the test should fail; used for "meta testing",
where we test the compiletest program itself to check that it will generate
errors in appropriate scenarios. This header is ignored for pretty-printer tests.
## Revisions
Certain classes of tests support "revisions" (as of the time of this
writing, this includes run-pass, compile-fail, run-fail, and
incremental, though incremental tests are somewhat
different). Revisions allow a single test file to be used for multiple
tests. This is done by adding a special header at the top of the file:
```
// revisions: foo bar baz
```
This will result in the test being compiled (and tested) three times,
once with `--cfg foo`, once with `--cfg bar`, and once with `--cfg
baz`. You can therefore use `#[cfg(foo)]` etc within the test to tweak
each of these results.
You can also customize headers and expected error messages to a particular
revision. To do this, add `[foo]` (or `bar`, `baz`, etc) after the `//`
comment, like so:
```
// A flag to pass in only for cfg `foo`:
//[foo]compile-flags: -Z verbose
#[cfg(foo)]
fn test_foo() {
let x: usize = 32_u32; //[foo]~ ERROR mismatched types
}
```
Note that not all headers have meaning when customized too a revision.
For example, the `ignore-test` header (and all "ignore" headers)
currently only apply to the test as a whole, not to particular
revisions. The only headers that are intended to really work when
customized to a revision are error patterns and compiler flags.