In the review of the original version of this series, Richard didn't
like the use of boolean parameters to parse_address_main. I think we
can just get rid of them and leave the callers to check the addressing
modes. As it happens, the handling of ADDR_SIMM9{,_2} already did this
for relocation operators (i.e. it used parse_address_reloc and then
rejected relocations).
The callers are already set up to reject invalid register post-indexed
addressing, so we can simply remove the accept_reg_post_index parameter
without adding any more checks. This again creates a corner case where:
.equ x2, 1
ldr w0, [x1], x2
was previously an acceptable way of writing "ldr w0, [x1], #1" but
is now rejected.
Removing the "reloc" parameter means that two cases need to check
explicitly for relocation operators.
ADDR_SIMM9_2 appers to be unused. I'll send a separate patch
to remove it.
This patch makes parse_address temporarily equivalent to
parse_address_main, but later patches in the series will need
to keep the distinction.
gas/
* config/tc-aarch64.c (parse_address_main): Remove reloc and
accept_reg_post_index parameters. Parse relocations and register
post indexes unconditionally.
(parse_address): Remove accept_reg_post_index parameter.
Update call to parse_address_main.
(parse_address_reloc): Delete.
(parse_operands): Call parse_address instead of parse_address_main.
Update existing callers of parse_address and make them check
inst.reloc.type where appropriate.
* testsuite/gas/aarch64/diagnostic.s: Add tests for relocations
in ADDR_SIMPLE, SIMD_ADDR_SIMPLE, ADDR_SIMM7 and ADDR_SIMM9 addresses.
Also test for invalid uses of post-index register addressing.
* testsuite/gas/aarch64/diagnostic.l: Update accordingly.
73866052f2