This instruction was added by Power ISA 3.0, using PPC2_PRCNTL makes it
available for older processors, like de e5500 and e6500.
Fixes: 7af1e7b02264 ("target/ppc: add support for hypervisor doorbells on book3s CPUs")
Signed-off-by: Matheus Ferst <matheus.ferst@eldorado.org.br>
Reviewed-by: Fabiano Rosas <farosas@linux.ibm.com>
Message-Id: <20221006200654.725390-3-matheus.ferst@eldorado.org.br>
Signed-off-by: Daniel Henrique Barboza <danielhb413@gmail.com>
On Power ISA v2.07, the category for these instructions became
"Embedded.Processor Control" or "Book S".
Signed-off-by: Matheus Ferst <matheus.ferst@eldorado.org.br>
Reviewed-by: Fabiano Rosas <farosas@linux.ibm.com>
Message-Id: <20221006200654.725390-2-matheus.ferst@eldorado.org.br>
Signed-off-by: Daniel Henrique Barboza <danielhb413@gmail.com>
We had only been reporting the stage2 page size. This causes
problems if stage1 is using a larger page size (16k, 2M, etc),
but stage2 is using a smaller page size, because cputlb does
not set large_page_{addr,mask} properly.
Fix by using the max of the two page sizes.
Reported-by: Marc Zyngier <maz@kernel.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-15-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Perform the atomic update for hardware management of the dirty bit.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-14-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Perform the atomic update for hardware management of the access flag.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-13-richard.henderson@linaro.org
[PMM: Fix accidental PROT_WRITE to PAGE_WRITE; add missing
main-loop.h include]
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Replace some gotos with some nested if statements.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-12-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Both GP and DBM are in the upper attribute block.
Extend the computation of attrs to include them,
then simplify the setting of guarded.
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-11-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Leave the upper and lower attributes in the place they originate
from in the descriptor. Shifting them around is confusing, since
one cannot read the bit numbers out of the manual. Also, new
attributes have been added which would alter the shifts.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20221024051851.3074715-10-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Always overriding fi->type was incorrect, as we would not properly
propagate the fault type from S1_ptw_translate, or arm_ldq_ptw.
Simplify things by providing a new label for a translation fault.
For other faults, store into fi directly.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-9-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
The unconditional loop was used both to iterate over levels
and to control parsing of attributes. Use an explicit goto
in both cases.
While this appears less clean for iterating over levels, we
will need to jump back into the middle of this loop for
atomic updates, which is even uglier.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-8-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
This fault type is to be used with FEAT_HAFDBS when
the guest enables hw updates, but places the tables
in memory where atomic updates are unsupported.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-7-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Separate S1 translation from the actual lookup.
Will enable lpae hardware updates.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-6-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-5-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
The MMFR1 field may indicate support for hardware update of
access flag alone, or access flag and dirty bit.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-4-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Hoist the computation of the mmu_idx for the ptw up to
get_phys_addr_with_struct and get_phys_addr_twostage.
This removes the duplicate check for stage2 disabled
from the middle of the walk, performing it only once.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Tested-by: Alex Bennée <alex.bennee@linaro.org>
Message-id: 20221024051851.3074715-3-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reduce the amount of typing required for this check.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20221024051851.3074715-2-richard.henderson@linaro.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
An exception targeting EL2 from lower EL is actually maskable when
HCR_E2H and HCR_TGE are both set. This applies to both secure and
non-secure Security state.
We can remove the conditions that try to suppress masking of
interrupts when we are Secure and the exception targets EL2 and
Secure EL2 is disabled. This is OK because in that situation
arm_phys_excp_target_el() will never return 2 as the target EL. The
'not if secure' check in this function was originally written before
arm_hcr_el2_eff(), and back then the target EL returned by
arm_phys_excp_target_el() could be 2 even if we were in Secure
EL0/EL1; but it is no longer needed.
Signed-off-by: Ake Koomsin <ake@igel.co.jp>
Message-id: 20221017092432.546881-1-ake@igel.co.jp
[PMM: Add commit message paragraph explaining why it's OK to
remove the checks on secure and SCR_EEL2]
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
FEAT_E0PD adds new bits E0PD0 and E0PD1 to TCR_EL1, which allow the
OS to forbid EL0 access to half of the address space. Since this is
an EL0-specific variation on the existing TCR_ELx.{EPD0,EPD1}, we can
implement it entirely in aa64_va_parameters().
This requires moving the existing regime_is_user() to internals.h
so that the code in helper.c can get at it.
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-id: 20221021160131.3531787-1-peter.maydell@linaro.org
The element size is encoded in the M3 field, not in the M4
field.
Fixes: be6324c6b734 ("s390x/tcg: Implement VECTOR ISOLATE STRING")
Resolves: https://gitlab.com/qemu-project/qemu/-/issues/1248
Message-Id: <20221012182755.1014853-3-thuth@redhat.com>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: David Hildenbrand <david@redhat.com>
Signed-off-by: Thomas Huth <thuth@redhat.com>
Sometimes dumping a guest from the outside is the only way to get the
data that is needed. This can be the case if a dumping mechanism like
KDUMP hasn't been configured or data needs to be fetched at a specific
point. Dumping a protected guest from the outside without help from
fw/hw doesn't yield sufficient data to be useful. Hence we now
introduce PV dump support.
The PV dump support works by integrating the firmware into the dump
process. New Ultravisor calls are used to initiate the dump process,
dump cpu data, dump memory state and lastly complete the dump process.
The UV calls are exposed by KVM via the new KVM_PV_DUMP command and
its subcommands. The guest's data is fully encrypted and can only be
decrypted by the entity that owns the customer communication key for
the dumped guest. Also dumping needs to be allowed via a flag in the
SE header.
On the QEMU side of things we store the PV dump data in the newly
introduced architecture ELF sections (storage state and completion
data) and the cpu notes (for cpu dump data).
Users can use the zgetdump tool to convert the encrypted QEMU dump to an
unencrypted one.
Signed-off-by: Janosch Frank <frankja@linux.ibm.com>
Reviewed-by: Steffen Eiden <seiden@linux.ibm.com>
Message-Id: <20221017083822.43118-11-frankja@linux.ibm.com>
Since the only user, Arm MTE, always requires allocation,
merge the get and alloc functions to always produce a
non-null result. Also assume that the user has already
checked page validity.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Use a constant target data allocation size for all pages.
This will be necessary to reduce overhead of page tracking.
Since TARGET_PAGE_DATA_SIZE is now required, we can use this
to omit data tracking for targets that don't require it.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
These memory allocation functions return void *, and casting to
another pointer type is useless clutter. Drop these casts.
If you really want another pointer type, consider g_new().
Signed-off-by: Markus Armbruster <armbru@redhat.com>
Reviewed-by: Laurent Vivier <laurent@vivier.eu>
Message-Id: <20220923120025.448759-3-armbru@redhat.com>
Signed-off-by: Laurent Vivier <laurent@vivier.eu>
