qemu-e2k

History

Avi Kivity a8170e5e97 Rename target_phys_addr_t to hwaddr target_phys_addr_t is unwieldly, violates the C standard (_t suffixes are reserved) and its purpose doesn't match the name (most target_phys_addr_t addresses are not target specific). Replace it with a finger-friendly, standards conformant hwaddr. Outstanding patchsets can be fixed up with the command git rebase -i --exec 'find -name "*.[ch]" \| xargs s/target_phys_addr_t/hwaddr/g' origin Signed-off-by: Avi Kivity <avi@redhat.com> Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>		2012-10-23 08:58:25 -05:00
..
cpu-qom.h
cpu.c
cpu.h
helper.c	Rename target_phys_addr_t to hwaddr	2012-10-23 08:58:25 -05:00
helper.h	target-lm32: switch to AREG0 free mode	2012-09-15 17:44:32 +00:00
machine.c
Makefile.objs	target-lm32: switch to AREG0 free mode	2012-09-15 17:44:32 +00:00
op_helper.c	target-lm32: switch to AREG0 free mode	2012-09-15 17:44:32 +00:00
README
TODO
translate.c	Emit debug_insn for CPU_LOG_TB_OP_OPT as well.	2012-09-27 21:38:50 +02:00

README

LatticeMico32 target
--------------------

General
-------
All opcodes including the JUART CSRs are supported.


JTAG UART
---------
JTAG UART is routed to a serial console device. For the current boards it
is the second one. Ie to enable it in the qemu virtual console window use
the following command line parameters:
  -serial vc -serial vc
This will make serial0 (the lm32_uart) and serial1 (the JTAG UART)
available as virtual consoles.


Programmatically terminate the emulator
----------------------------------------
Originally neither the LatticeMico32 nor its peripherals support a
mechanism to shut down the machine. Emulation aware programs can write to a
to a special register within the system control block to shut down the
virtual machine.  For more details see hw/lm32_sys.c. The lm32-evr is the
first BSP which instantiate this model. A (32 bit) write to 0xfff0000
causes a vm shutdown.


Special instructions
--------------------
The translation recognizes one special instruction to halt the cpu:
  and r0, r0, r0
On real hardware this instruction is a nop. It is not used by GCC and
should (hopefully) not be used within hand-crafted assembly.
Insert this instruction in your idle loop to reduce the cpu load on the
host.


Ignoring the MSB of the address bus
-----------------------------------
Some SoC ignores the MSB on the address bus. Thus creating a shadow memory
area. As a general rule, 0x00000000-0x7fffffff is cached, whereas
0x80000000-0xffffffff is not cached and used to access IO devices. This
behaviour can be enabled with:
  cpu_lm32_set_phys_msb_ignore(env, 1);